Automatic Thermal Vapor Recompression TVR Evaporator
TVR evaporation and concentration equipment
It is an evaporation concentration crystallization equipment which uses TVR heat pump to recompress part of secondary steam as heat source of heating chamber.
The supply conditions for stable supply of saturated steam above 0.7MPa are required.
The performance of TVR is directly related to the effect of steam saving, so it is necessary to use products with guaranteed operation performance.
If the quality and performance of TVR is poor, the steam saving effect is not obvious, and it is easy to damage because of the noise and vibration.
The solution is preheated with condensate and enters the evaporation circuit. Here it mixes with the circulated solution and is warmed up in heater H. In the evaporator V, solvent (water) evaporates while cooling the solution to the boiling temperature. The resulting vapour steam is compressed to a higher pressure and temperature level by the steam jet pump with the help of steam, so that it can be used as a heating medium for heating the circulated solution. The excess vapour is condensed. If salt shall be crystallized in the plant, further evaporation concentrates the solution to such an extent that crystals are formed. If desired, the crystals in the suspension can then be separated from the solution and dried.
Only a fraction of the evaporation energy has to be used in the form of live steam.
Low investment costs.
Retrofitting in existing plants is possible.
Suitable for various applications.
Long production runs due to high hygienic standards
Fully cleanable (Cleaning in Place)
Water evaporation capacity (T / h)
This equipment is a continuous concentration equipment, which is composed of TVP steam heat pump, heating tube, evaporation chamber, condenser, vacuum pump, circulating discharge pump and operation platform. It is suitable for concentration in food, pharmaceutical, chemical, bioengineering, environmental engineering, waste liquid recovery and other industries. This equipment adopts TVR heat pump technology, so as to save a lot of energy. Adding TVR heat pump can save energy, at least equivalent to one more effect, that is, the steam consumption of four effect + TVR is basically the same as that of five effect.
|Performance Comparison for Different Evaporator|
|Item||Single effect evaporator||multi-effect evaporator||TVR evaporator||MVR evaporator|
|Energy consumption||energy consumption is much higher than others, 1ton water will consume 1Ton steam in theory||comparatively energy conservation||Base on traditional multi-effect evaporator, one more effect added, but higher pressure steam driven needed||The most energy saving technology for evaporator, but 10-40kwh power consumption|
|Energy sources||steam & power, need steam pipe network and boiler||steam & power, need steam pipe network and boiler||steam & power, need steam pipe network and boiler, need high pressure steam.||electricity, don't need pipe network, all the close-loop circulation system|
|Automaticity||Semi automatic||Full automatic operation, continuous evaporation||Full automatic operation, continuous evaporation||Full automatic operation, continuous evaporation|
Production & installment facility